Why is FreeBSD finding the wrong amount of memory on i386 hardware?
The most likely reason is the difference between physical memory addresses and virtual addresses. The convention for most PC hardware is to use the memory area between 3.5 GB and 4 GB for a special purpose (usually for PCI). This address space is used to access PCI hardware. As a result real, physical memory can not be accessed by that address space. What happens to the memory that should appear in that location is dependent on your hardware. Unfortunately, some hardware does nothing and the ability to use that last 500 MB of RAM is entirely lost. Luckily, most hardware remaps the memory to a higher location so that it can still be used. However, this can cause some confusion if you watch the boot messages. On a 32-bit version of FreeBSD, the memory appears lost, since it will be remapped above 4 GB, which a 32-bit kernel is unable to access. In this case, the solution is to build a PAE enabled kernel. See the entry on memory limits and about different memory limits on different platfo
The most likely reason is the difference between physical memory addresses and virtual addresses. The convention for most PC hardware is to use the memory area between 3.5 GB and 4 GB for a special purpose (usually for PCI). This address space is used to access PCI hardware. As a result real, physical memory can not be accessed by that address space. What happens to the memory that should appear in that location is dependent on your hardware. Unfortunately, some hardware does nothing and the ability to use that last 500 MB of RAM is entirely lost. Luckily, most hardware remaps the memory to a higher location so that it can still be used. However, this can cause some confusion if you watch the boot messages. On a 32 bit version of FreeBSD, the memory appears lost, since it will be remapped above 4 GB, which a 32 bit kernel is unable to access. In this case, the solution is to build a PAE enabled kernel. See the entry on memory limits and about different memory limits on different platfo
The most likely reason is the difference between physical memory addresses and virtual addresses. The convention for most PC hardware is to use the memory area between 3.5GB and 4GB for a special purpose (usually for PCI). This address space is used to access PCI hardware. As a result real, physical memory can not be accessed by that address space. What happens to the memory that should appear in that location is dependent on your hardware. Unfortunately, some hardware does nothing and the ability to use that last 500MB of RAM is entirely lost. Luckily, most hardware remaps the memory to a higher location so that it can still be used. However, this can cause some confusion if you watch the boot messages. On a 32bit version of FreeBSD, the memory appears lost, since it will be remapped above 4GB, which a 32bit kernel is unable to access. In this case, the solution is to build a PAE enabled kernel. See the entry on memory limits and about different memory limits on different platforms fo
