Why doesn the Allocation profiler display results?
A.: You most likely have an active filter applied to the results. Make sure that you do not have filters that hide the objects from the report: • Press the Filter button on the Report panel’s toolbar and disable the filter in the ensuing Filter dialog. • Try disabling the Filter leaks setting on the Report panel’s toolbar. Another reason for hiding leaks is that you profiled your application with the active Show leaks for Setup modules setting (you can enable or disable this setting on the Report panel’s toolbar). If the setting is enabled, AQtime only displays profiling results for those modules that are added to the Setup panel. If the setting is disabled, AQtime shows the results for all modules used by the profiled application. So, if the setting is active and the leak occurred in the module that is not added to your AQtime project, AQtime will display no information about the leak. Note that this setting only effects the Objects category of the profiling results and is ignored whe
