Where Should I place the SCSI host adapter on the SCSI bus?
The placement of the SCSI adapter card can be on the end, at the beginning, or somewhere in the middle of the SCSI bus. Quite frankly, placement of the controller card isn’t special. The adapter card is just another device on the SCSI bus. As long as the rules above and in other sections of this FAQ are followed, there should be no problem placing the adapter card anywhere on the SCSI bus. However, if you place the adapter card somewhere in the middle of the SCSI bus, you must be sure to disable termination on the adapter card. As noted previously, a SCSI device is only allowed to have termination if it’s at the end of the bus. Only two terminators are allowed to terminate the SCSI bus, one at each end. One last note: It doesn’t make any difference where each SCSI ID is placed along the bus. It only matters that no two devices have the same ID. Don’t forget that the adapter has an ID too. (Usually ID 7).
