When sending data to or from the PT 2000, why is only the first record of data is actually sent?
Warnings Resetting the PT 2000 will delete any and all data stored on the unit. Solution Reset the communications parameters so that the transfer protocol used by the PT 2000 matches the protocol used on the host computer. Do this by scanning a command bar code in Appendix H of the PT 2000 User’s Guide, section “Serial Parameters”, sub-section “Protocol”. The command code to scan depends on a specific situation. If you are trying to use the PSC Portable File Transfer utility (PDTFER.EXE or PDTFER.EXE) then you need to scan the protocol bar code labeled “CR with checksum and ACK/NAK response”. This will turn the default PT 2000 transfer protocol back on. If you are using Hyperterminal, ProComm or another generic communication utility and are attempting to transfer data as a simply ASCII data dump, you will need to scan the protocol bar code labeled “EOR only”. This will turn the default PT 2000 transfer protocol off. If neither of these bar codes helps and the problem persists, it may r
