What causes earthquakes?
What causes earthquakes? The short answer is that earthquakes are caused by faulting, a sudden lateral or vertical movement of rock along a rupture (break) surface. Here’s the longer answer: The surface of the Earth is in continuous slow motion. This is plate tectonics–the motion of immense rigid plates at the surface of the Earth in response to flow of rock within the Earth. The plates cover the entire surface of the globe. Since they are all moving they rub against each other in some places (like the San Andreas Fault in California), sink beneath each other in others (like the Peru-Chile Trench along the western border of South America), or spread apart from each other (like the Mid-Atlantic Ridge). At such places the motion isn’t smooth–the plates are stuck together at the edges but the rest of each plate is continuing to move, so the rocks along the edges are distorted (what we call “strain”). As the motion continues, the strain builds up to the point where the rock cannot withst
An earthquake is the shaking of the ground caused by an abrupt shift of rock along a fracture in the Earth, called a fault. Within seconds, an earthquake releases stress that has slowly accumulated within the rock, sometimes over hundreds of years. … The size of an earthquake is indicated by a number called its magnitude. Magnitude is calculated from a measurement of either the amplitude or the duration of specific types of recorded seismic waves. Magnitude is determined from measurements made from seismograms and not on reports of shaking or interpretations of building damage. … The intensity of and earthquake is a measure of the amount of ground shaking at a particular site, and it is determined from reports of human reaction to shaking, damage done to structures, and other effects. … Earth scientists believe that most earthquakes are caused by slow movements inside the Earth that push against the Earth’s brittle, relatively thin outer layer, causing the rocks to break suddenly
This earthquake occurred as the result of stresses generated by the motion of the Arabian plate northward against the Eurasian plate at a rate of approximately 3 cm/yr (about one inch per year). Deformation of the Earth’s crust in response to the plate motion takes place in a broad zone that spans the entire width of Iran and extends into Turkmenistan. Earthquakes occur as the result of both reverse faulting and strike-slip faulting within the zone of deformation. Preliminary analysis of the pattern of seismic-wave radiation from the December 26 earthquake is consistent with the earthquake having been caused by right-lateral strike-slip motion on a north-south oriented fault. The earthquake occurred in a region within which major north-south, right-lateral, strike-slip faults had been previously mapped, and the epicenter lies near the previously mapped, north-south oriented, Bam fault.
