That Handle On The NC Is Not Quite Where I Need It To Be. Whats The Recommended Way To Bend It?
You might need to bend it to suit your own hand and style because for some reason they aren’t bending the handles far enough . What I use is an old ratchet wrench I have that has a hole in the end of the handle you use to hang it up with. If you know someone who has a lot of tools they may have something similar you could borrow. The hole needs to just fit that rod and allow you some leverage so you can bend the metal. Another thing you can use is a piece of oak plank cut about 2″ wide and 7 or 8″ long. It needs to be about 1 inch thick. Drill a hole in one end a little bigger than the handle and you can bend it with that. If you have to bend the handle at the knobbed tip remember that the knob unscrews. Take the tip off sos not to break it at the threads. Bend the end around straight and bend it up a little then bend the handle back where the first bend is. You can make it higher or lower according to your needs. Bend in small increments. A little goes a long way. You might want to wa
