Suppose it fails to stop?
What should you do if the engine stop switch has no effect? Probably the safest and surest is to use a wooden stick to pop the spark plug connector off of the spark plug terminal. This **will** stop the engine. The most likely cause of such misbehavior is a stop wire that has become disconnected or has broken. This is easily remedied. • Back to Small Engine Repair FAQ Table of Contents. Maintenance Guide General preventive maintenance Here is what you should do at the end of the mowing season: • Change the oil. If you do nothing else in this list, at least change the oil. Old dirty oil will shorten the life of your engine and affect its starting and running performance eventually. • Drain the fuel tank (see the section: Gasoline for tips on doing this). Put this and any fresh (unmixed) gas remaining in your gas supply can into your car’s fuel tank (preferably at least half full to dilute it) so you won’t be tempted to use it next season.
What should you do if the engine stop switch has no effect? Probably the safest and surest is to use a wooden stick to pop the spark plug connector off of the spark plug terminal. This **will** stop the engine. The most likely cause of such misbehavior is a stop wire that has become disconnected or has broken. This is easily remedied. • Back to Small Engine Repair FAQ Table of Contents. Maintenance Guide General preventive maintenance Here is what you should do at the end of the mowing season: • Change the oil. If you do nothing else in this list, at least change the oil. Old dirty oil will shorten the life of your engine and affect its starting and running performance eventually. • Drain the fuel tank (see the section: Gasoline for tips on doing this). Put this and any fresh (unmixed) gas remaining in your gas supply can into your car’s fuel tank (preferably at least half full to dilute it) so you won’t be tempted to use it next season. Or, discard it in an environmentally friendly ma
Related Questions
- My firewall starts and restarts fine but if I try shorewall restore, the script fails because none of my shell variables from /etc/shorewall/params are set. Why?
- If the installation fails, was there a prior installation attempt? Was the MS$FG8 folder removed before attempting to install again?
- What happens if a program fails to submit a Self Report?
