Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

Is the wind speed/direction and humidity being displayed correctly on the ULTIMETER 2000 keyboard?

0
Posted

Is the wind speed/direction and humidity being displayed correctly on the ULTIMETER 2000 keyboard?

0

If the wind speed/direction and humidity is not being displayed on the ULTIMETER 2000 KEYBOARD, it is a Hardware problem with the ULTIMETER 2000. Please contact Peet Bros. Back to Top ———————————————————————– QUESTION: When I start WeatherLogger (Peet software), it reads data from com-port. If I start WAIS at the same time, it complains that port is taken by another process, which is fine. But if I shut down WeatherLogger and try to run only WAIS, on COMM TEST button it says “No Wx detected”. Also, CONSOLE tab is blinking and doesn’t show anything. ANSWER: Sometimes if you run Peet software, it can take over the serial port and does not close it properly when you terminate it. Then if you run WAIS, the serial port is not available to WAIS. The only solution after running the PB software is to shutdown and reboot the computer and then run WAIS. Back to Top ———————————————————————– QUESTION: I n

0

If the wind speed/direction and humidity is not being displayed on the ULTIMETER 2000 KEYBOARD, it is a Hardware problem with the ULTIMETER 2000. Please contact Peet Bros. Back to Top ———————————————————————– QUESTION: When I start WeatherLogger (Peet software), it reads data from com-port. If I start WAIS at the same time, it complains that port is taken by another process, which is fine. But if I shut down WeatherLogger and try to run only WAIS, on COMM TEST button it says “No Wx detected”. Also, CONSOLE tab is blinking and doesn’t show anything. ANSWER: Sometimes if you run Peet software, it can take over the serial port and does not close it properly when you terminate it. Then if you run WAIS, the serial port is not available to WAIS. The only solution after running the PB software is to shutdown and reboot the computer and then run WAIS. Back to Top ———————————————————————– QUESTION: I n

Related Questions

What is your question?

*Sadly, we had to bring back ads too. Hopefully more targeted.

Experts123