How to get adhesion data?
OK, so you have some force plots and you want to get a histogram of adhesion values, here’s how to do that. 1) Load your data into the Force review panel, which is started from the MFP IP -> Force Display Panel Menu. 2) Go to the analyze tab. 3) Make sure that first popup is adhesion. 3.1) If you only want to look at a subset of the data, check your limits (Start index and Stop Index). 3.2) Note that these are indexes, Not suffixes, so use the values for the indexes on the display tab. For example you want to look at the adhesion values for data from ForcePlot0010 to ForcePlot0078. Go to the display tab, select ForcePlot0010, record the value listed in the Index control, and enter that value in Start Index on the analyze tab. Then go back to the display tab and select ForcePlot0078, record the index and enter it in Stop Index on the analyze tab. 4) Check the Histogram checkbox. 5) Yeah it is that easy. So what are you looking at? It is the difference between the lowest point in the ret
