How is the SPT applied?
Step 1: Sweep area and use SPT Degreaser and hot water with a deck brush or power scrubber. Let it stand 1-2 minutes, then rinse with warm water. Surface does not need to be dry before applying the non-slip—just be sure soap has been removed and there is no standing water. Step 2: Spray (common hand pump sprayer) SPT non-slip on degreased area. Be sure to split large areas into smaller sections when applying non-slip. You want to keep the area you are applying non-slip to saturated at all times, If the non-slip is drying between 10-15 min. then just spray more SPT non-slip over the area. When area is covered let it set for about 10-15 min. Step 3: After 10-15 min. rinse with cold water to activate the non-slip. Squeegee the water into the drain or remove it with a shop vacuum. There is no curing time required; you can walk over floor as soon as the application is complete.
