How does the inverter react for the different possible values of parameter P1210 Auto restart?
P1210 is the parameter which enables a restart after a mains break or after a fault.The possible values for P1210 are described in the parameter list, but a more detailed explanation is as follows:P1210 = 0: Automatic restart is disabled – i.e. it is switched off so the inverter will not restart without toggling the ON command.P1210 = 2: The inverter will restart after a mains blackout when the power is re-applied. The ON command does not need to be toggled. The inverter will not restart after a brownout (a very short mains break where the DC link has not fully collapsed). It will show an F0003 which needs to be reset before the inverter can be made to run by toggling the ON command.P1210 = 3: The inverter will restart after either a fault or a mains interruption of any duration.P1210 = 4: The inverter will restart after a mains interruption of any duration. Any other fault will need to be reset and the run signal should be toggled.P1210 = 5: The inverter will restart after a mains bre
