How Do You Reassemble A Hayward Aquabug?
Once you’ve removed all the parts of the Hayward Aquabug, inspected and replaced any worn or broken parts, it’s time to reassemble the Aquabug. The best way to fit everything together is to assemble the individual components before putting them back into the shroud. Here’s how to get the cone gear and the upper middle body assembly back into the shroud. Set the upper middle body assembly right side up on a workbench. Check the placement of the clear plastic cone gear on top of the assembly over the cone gear bushing on the suction hole. The cone gear should sit flat and engage the upper gear so the two gears turn together and the teeth mesh. Pick up the upper middle body from underneath. Hold it relatively level, since the gears are held together only by gravity. Take the Aquabug’s shroud in your other hand, holding it by the small protrusion toward the back and lower it over the upper middle body assembly. Guide the top of the cone gear into the hole in the center of the shroud. Slip
