Can the CM-2000 configuration module used with the ART-2000 be programmed by devices other than the KPA-900 programmer?
The CM-2000 Configuration Module saves the configuration and calibration information for the ART-2000/RDR-2000 system. The module can be programmed with configuration data via EFIS-40/50 with EFIS software level 09 or higher. Otherwise, the Configuration Module must be programmed with configuration data outside the system using the KPA-900 Configuration Module Programmer Kit #P/N 050-03311-0003# with a personal computer. All calibration data is programmed with the module in the system regardless of the type of installation. Please note that while the CM-2000 configuration modules stores certain aircraft specific parameters that are utilized by the system, other adjustments and settings must be made in the system following installation. Please refer to the RDR-2000 Installation Manual for complete details on the proper way to configure the RDR-2000 / ART-2000 system.
Related Questions
- What ProCurve Networking Mini-GBICs are supported in the ProCurve Switch XL Mini-GBIC Module used with the ProCurve Switch 5300XL Series?
- Can the CM-2000 configuration module used with the ART-2000 be programmed by devices other than the KPA-900 programmer?
- Do Altera Devices scan differently when they are blank vs when they are programmed?
