With the Management via Wireless feature enabled on wireless LAN controllers (WLCs) in a mobility group, I can only access one WLC from that mobility group, but not all. Why?
A. This is an expected behavior. When enabled, the Management via Wireless feature allows a wireless client to reach or manage only the WLC to which its associated access point is registered. The client cannot manage other WLCs, even though these WLCs are in same mobility groups. This is implemented for security, and recently was tightened down to just the one WLC in order to limit exposure. The Cisco WLAN Solution Management over Wireless feature allows Cisco WLAN Solution operators to monitor and configure local WLCs using a wireless client. This feature is supported for all management tasks, except uploads to and downloads from (transfers to and from) the WLC. This can be enabled through the WLC CLI with the config network mgmt-via-wireless enable command. On the GUI, click Management; from the left-hand side click Mgmt Via Wireless, and check the box Enable Controller Management to be accessible from Wireless Clients. Note: When you enable this option, you can expose the data. Ensu
Related Questions
- Are there any basic requirements to maintain when I use the mobility anchor feature in order to configure wireless LAN controllers (WLCs) for guest access?
- What is the maximum number of APs supported on the 4402 and 4404 wireless LAN controllers (WLCs)?
- Do Cisco Wireless LAN Controllers (WLCs) support the failover (or redundancy) feature?
