Why does the rear arm of the VERSArm HD appear to be welded on an offset?
That’s because it is offset; to assemble the rear arm to the front main beam you must have someone hold the drivers side of the arm up approximately 2″ +/- 1″ to allow the pivot/hinge ears to align. Once the holes are aligned insert the bolt and tighten until the arm no longer swings freely. Then close the arm by applying pressure to the latch end to force the arm down and into the latch ears. After the grill is attached to the arm the weight of the grill will help hold the arm down. The arm was elevated on the end to reduce the need to lift the grill into the latch ears when closing.
