Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

Why does NasFinder report “No Servers Found” during the scan process?

April 26, 2017nasfinder process report scan

0

Posted

Why does NasFinder report “No Servers Found” during the scan process?

1 Answer

0

Posted

There are two main causes of this problem. The first would be that the SimpleShare has not completely booted up. Check the front to see if the Blue Ready LED is on. If it is not, do the following. • Check to make sure that the power cord is plugged in. When the power cord is connected the drive should start automatically. You should see the Amber Power LED from the moment of connection to power and the Blue Ready LED should appear within 2min. • If the Amber Power LED is showing, but not the Blue Ready LED, then you may need to wait longer for the drive to boot up. If it has been more than 5min since you connected power to the drive, then the drive needs to be rebooted. • First push the power button on the rear of the SimpleShare. Make sure to depress it completely and the unit will shutdown within 1min. You will know it is completely shutdown when the Amber Power LED goes off. Then depress the power button again to restart the SimpleShare. • If the SimpleShare will not power down by t