Why does MultEQxt correct beyond 300 Hz?
There is a belief that room correction should only be applied to frequencies below 300 Hz or so because that is the frequency range in which most of the room problems occur. This belief is based on an inherent assumption that a properly designed loudspeaker will perform as desired at higher frequencies and thus require no correction. This is not at all contradictory to MultEQxt. If the loudspeaker is in fact properlly designed then no correction will be applied to it. One simple fact that the proponents of this theory seem to overlook is that even the best designed loudspeakers will suffer from artifacts at high frequencies produced by reflections from nearby flat surfaces such as plasma screens or cabinets. MultEQxt performs this kind of correction when it is needed to allow the loudspeaker to achieve the performance it was designed to have.
