Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

Why do I receive the message “Scanner not found” when I go into CADImage/SCAN?

April 26, 2017cadimage message scan

0

Posted

Why do I receive the message “Scanner not found” when I go into CADImage/SCAN?

1 Answer

0

Posted

CADImage/SCAN searches the SCSI bus looking for the CalComp scanner. This message states that Windows is not logging this as a valid device. The problem may be due to the scanner being turned on after the computer. Always turn on the scanner before the computer. If a device is not present and ready during the Windows SCSI probe during boot-up, it will not install that device.