Why do I get a “Failed To Acknowledge” message when WinMasterCG is started?
There are two possible reasons for this error: either the baud rate is not matched with the device being controlled, or there is a connection problem with the device. Make sure the cable is of the proper type. In some cases a straight through cable is used and in others a null modem cable is required. There may be a problem with the connection to the PC. Be sure the cable is connected to the proper serial port. If after checking the above you are unable to establish communications, close WinMasterCG and open HyperTerminal. HyperTerminal can be found in the accessories folder of Windows. Set up a direct connection in HyperTerminal, usually at 9600 baud, 8 data bits, one stop bit, no parity, and no flow control. If the problem is the Codi not responding, you should be able to simply type in HyperTerminal and see the characters appear on the Codi program video out. Once you can type characters to the Codi be sure the connection is complete by issuing an acknowledge request command with th
Related Questions
- When the machine is restarted, however, the error message "A Service Could Not Be Started ....see Event Protocol" is displayed. How can I get around this message?
- I started RestoreIT™ in Windows immediately after installation completed, but a message says that I have to restart my computer in order to run it. Why?
- Why do I get a "Failed To Acknowledge" message when WinMasterCG is started?
