While Easy CD is creating the virtual file data base, before it begins writing, I have gotten something similar to the following error: Virtual database error 39-00-00-00 What is going on, and what can I do about it?
• 05.06: Why have I begun to get intermittent “Calibration Area Full” errors when I attempt to burn a CD? • 05.07: What does buffer underrun mean? • 05.08: Where can I find a list of Easy CD error codes and what they mean? • 05.09: Whenever I get about 70% of a CD written, the 4020i stops and says “write append error.” Also, when I try to select “Close Disc” the drive starts writing but then stops and reports “Internal Controller Error.” What going on here? • 05.10: After a buffer underrun, the disc remains unclosed (as indicated by the diagnose program). How do I close the disc and why can I only access the last written session but no sessions prior to that? • 05.11: Is it enough to just disable Advanced Power Management by software? • 05.12: When I attempt to read multisession CDs with the 4020i drive, only the most recent session shows up, but in other CD-ROM drives all the sessions are visible. • 05.13: Where can I find information pertaining to using the 4020i with OS/2?
Related Questions
- While Easy CD is creating the virtual file data base, before it begins writing, I have gotten something similar to the following error: Virtual database error 39-00-00-00 What is going on, and what can I do about it?
- If there is an area in which data is not fully finished writing is the area reused when creating a new file or is the area not reused until after its been reformatted?
- Does Tar98 do any data validation, checking, or verifying when writing data to a tar tape or file?
