Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

Where should the termination resistors be populated?

April 26, 2017populated resistors termination

0

Posted

Where should the termination resistors be populated?

2 Answers

0

Posted

When there are two PHY transceivers both connected to the B side of the PI3L301D switch, and one PHY is far away from the switch, it is suggested to populate the termination resistors between the switch and PHY’s as close to the PHY as possible, within 3mm is feasible.

0

10 Posted

When there are two Phy transceivers both connected to the B the termination resistors among the side of the Pi3L301D switch switch and Phy’s as close to the Phy, and one Phy is far away from the switch, it is suggested to populate as possible, within 3mm is feasible.sw(‘pg97720f’);