Where is the air bleed valve for the cooling system on a 95 mercury villager?
There are accually three. One is on the right side of the radiator, another on top of the intake manifold and a bleed tube which is capped, its located about a foot left and a foot below the brake master cyclinder. You can’t see it but you can reach down and feel a 1/4 tube with a rubber cap on it. if you need to bleed the coolant system you must first loosen the bleed plug on the radiator and fill the radiator untill coolant startes to come out then tighten that bleed plug, next loosen the plug on top of the manifold and squeese the upper radiator hose to explell air out the intake bleed plug while adding coolant to the radiator. This will take several attempts.once coolant come out steady from the intake bleed port, tighten the plug. Next On the bleed tube remove the cap and use a piece of wire to stick inside the tube to make sure its open then slide on a three foot clear rubber hose on the bleed tube and run the other end to your overflow tank making sure its submered in the coolan
