Where do I get replacement lights for my Vetter TailTrunk?
One Vetter owner reports the following: Optronics part #MCL-57RK. It is a 3-piece kit consisting of a light, pigtail assembly, and rubber grommet. Purchased at Advance Auto for $11.88 each. One hole in the trunk is left unmodified, so that you can see the silver line marked out to show where plastic needs to be trimmed away. Note that it is not quite the diameter of the two side slots. The hole needs to be enlarged to 3 inches in diameter, which is approximately the diameter between the outsides of the top and bottom rivet holes. A Dremel rotary tool with an appropriate bit, used carefully, does a decent job (move counter-clockwise around the hole to minimize kickback and tool wander). Connect the white wire (“hot”) of the light pigtail to the green wire of the trunk harness, and the black wire (“ground”) to the black wire of the trunk harness. These lights are especially great for bikes with a low-amp charging system, as the LED lights draw VERY little current. In fact, once you turn
