When trying to start the analyzer I get a message: There is no such node or vector. Where is my error?
The first thing to do in this case is to check the contents of the .sim file (the one that IRSIM uses for the simulation). Sometimes during the conversion from .spc to .sim, a blank file is created (usually due to a typing error when you enter the command) and it cannot be overwritten. To fix that, just delete the empty .sim file and do the conversion again. If this does not work, you should check the schematic (or the layout) to make sure that all labels with node names are clearly specified. Q3: My simulation results show some undefined values for certain input combinations.
Related Questions
- Every time I save a node in the node editor, an error dialog is shown, containing the following message "Run-time error 398: Application-defined or object-defined error". Why does this happen?
- When Heartbeat starts up I get this error message in my logs: "WARN: process_clustermsg: node [
] failed authentication". What does this mean? - When trying to start the analyzer I get a message: There is no such node or vector. Where is my error?
