When I try to start up TransferPro I get the error message “Sorry, Unlicensed!”. How can I get TransferPro to start up?
A – If you have not yet obtained a password and entered it using the “install_license” program as described in Chapter 1 of the TransferPro User Guide, then perform the steps in Chapter 1 in the section titled “Licensing and configuration instructions”. Make sure when entering the password, that the dash character (-) separates each group of four numbers. If you have entered spaces instead of dashes, the password will be interpreted incorrectly. If you have run the install_license program as described in Chapter 1, and properly entered the password, the usual cause of the “Sorry, Unlicensed!” message is that you are trying to launch the wrong version of TransferPro. Most release media now include both the command-line version of TransferPro and the Graphical User Interface version. Make sure you are starting the version you have purchased. The executable names of the UNIX versions of TransferPro are as follows: • tprom – The Motif graphical user interface version on all platforms excep
Related Questions
- I keep getting an Error Message when I try to access an item on the UCSO website (Personal Information Calendar, Bidding CSJ, Registration Information, etc). What should I do?
- Why do I get an error message when I try to create a project in the BeadStudio 2 Gene Expression Module with both 6x2 and 8x1 BeadChips?
- When I try to start up TransferPro I get the error message "Sorry, Unlicensed!". How can I get TransferPro to start up?
