When I load my routes from my GPS unit into NavPlanner, only the points are showing, not a route line connecting them. What do I do?
Click on “Route-Create a new route”. Then click on the first waypoint that you have in the route and answer yes when asked if you want to have this waypoint included in the route. Then continue clicking on the rest of the waypoints you would like included in the route, when finished right click on your mouse and choose end route. Q.>I am getting an error message of Cannot create directory [g:waypts\] (The g could be any letter as this is the drive the memory card is in) when saving created routes or waypoints to a blank SD card. What is wrong? A: First, make sure that you are not attempting to save to your Navionics card as you only want to save to a blank media card. Saving to your Navionics card can corrupt your chart data. This error is created when the SD card is in the locked position, which will prevent you from saving to the card. Remove the SD card from the reader and move the lock button into the unlocked position.
Related Questions
- When I have a static route and RIP configured on a router, why is it that the static route with an administrative distance of 1 is preferred over RIP routes with an administrative distance of 120?
- When I load my routes from my GPS unit into NavPlanner, only the points are showing, not a route line connecting them. What do I do?
- What comparable American cities have built a transit route similar to the Red Line?
