What ports does ProEdgeTrader use?
ProEdgeTrader uses port 9200 for orders and port 9201 for data. To check if these ports are open on your computer go to “Start” > “Run” and type “cmd” (without quotes) and press “OK”. This will open the comand prompt window where you will type the following, (without quotes): ” telnet prod.openecry 9200″ and then press enter on your keyboard. If you get foreign characters, this verifies communication to port 9200 and means this port is open. If you get an error message then the firewall is blocking the port. Note the above instructions are for Windows XP, Telnet needs enabled in Windows Vista and Windows 7. In order to enable and install Telnet in Windows 7, the steps are easy, and similar to procedures to turn on and enable Telnet in Windows Vista: • Open Control Panel. • Go to Programs or Programs and Features. • Click Turn Windows features on or off. • In the “Windows Features” dialog box, select (tick) the Telnet Client check box. • Click OK. • After installation is done, Telnet ca
