What kind of network do I need for WinDyn, and how do I install it?
SuperFlow suggests an Ethernet Workgroup Hub. We have several in use here and rarely have any problems with them. Various products are available, but we recommend a Linksys model number EWHUB. It has eight ports, one of which is a BNC type connector. A 10-port model is also available. It is important that the hub has a BNC port because the dyno uses BNC type connectors. • To install the Ethernet hub on your network, first place a BNC “T” on the hub. Then locate the network connection on the back of both computers. You should find a BNC T-connector with a coax cable on one side and a 50-ohm terminator on the other. Remove the 50-ohm terminator from both computers. • Install a similar coax cable from the open T on each computer to the workgroup hub. Be sure the type of coax cable is the same as the cable currently used. We supplied RG58U cable with BNC connectors which should be available at local electronic or computer stores. If not, we have plenty. • Now configure the dyno network wit
