What is the warranty for ConMet hubs and what is covered?
31. Where can I get more information? Call ConMet Customer Service at 800-547-9473, or browse our Hub Literature Section. back to top 32. Will a ConMet wheel stud or axle stud fit my non-ConMet hub? Can I use a ConMet fastener in my design? No. ConMet studs are designed for use only in ConMet hubs and should not be used in any other brand of product. Aftermarket sales of ConMet studs is intended for replacement of parts in service. Hardware for general use should be obtained from aftermarket stud manufacturers. back to top 33. I’m experiencing vibration and/or tire wear. How much runout is allowed on my hub? Up to .008 inch axial and radial flange runout is allowed relative to the axle. The wheel and drum pilots can be confirmed by measuring the outer flange since they are machined at the same time. During measurement the bearings must be set with zero endplay. The PreSet ® or LMS™ spacer between the bearings, if one is present, must be removed to accomplish this. Take care not to misa
