What is the recommended gain staging for Model I systems when using with a T1?
1. Make sure the Power switch on the power stand is in the OFF position and the R1 remote control is disconnected. Note: The R1 remote control should be disconnected so that the T1 ToneMatch® Audio Engine solely controls the volume of the L1® Model I system. 2. Make sure the T1 power switch is in the OFF position and the T1 audio engine power supply is connected. 3. Make sure the T1 Master volume control is set to 0. 4. Plug one end of a ¼” phone plug cable (not supplied) into the Master output port on the T1. Plug the other end of the ¼” phone plug cable into the Channel 3 (or Channel 4) Line IN jack on the L1 power stand. 5. Set the Line IN Level control on the power stand to approximately 2. NOTE: This setting has been revised to 3 or 4 ref: T1 ToneMatch™ Audio Engine: Power Stand Input Setting 6. Turn on the T1 audio engine. 7. Turn on the L1 Model I power stand. Note: In some circumstances, it may be necessary to slightly adjust the Line IN Level control from this initial setting
Related Questions
- Whats the proper method for setting the gain on a Model II power stand when connected to a T1 ToneMatch audio engine?
- What is the recommended way to set the gain for a Model I system when using it with a T1 ToneMatch audio engine?
- What is the recommended gain staging for Model I systems when using with a T1?
