What is the proper way to replace a PIC chip on a Teleo Module?
Tools required: small flat blade screwdriver Precautions: 1. The PIC and other components can be damaged by static electricity. In order to discharge any static electricity you may carry, touch a grounded object such as the metal case of a grounded computer or a cold water pipe 2. The pins on the PIC are delicate. Procedure: 1. Identify the PIC (see image). Note the index mark and notch near the 5-pin connector. 2. Gently slip the tip of the scredriver between the PIC and the socket from the end nearest the LED. 3. Gently rotate the screwdriver to lift the near end of the PIC out of the socket. 4. Avoid lifting the PIC out at an angle. Slip the screwdriver in further and rotate again. Continue doing so until you reach the other end of the PIC (near the 5-pin connector). 5. Continue to pry up the PIC at each end until it is free from the socket 6. The replacement chip should be placed in the same direction as the original, with the index mark and notch near the orange connector. 7. Make
