What is the operating speed and output torque of the steering servo (part #29126) for the Monster GT at 4.8 and 6 volts?
We have the readings at 6.0v– it is .19 sec and 111.0 oz. inches of torque. 26 The larger motors (.24-.28) still mount in the same space as a .21. Here is a tip for anybody who needs help with the CVD builds. 1st step, CLEAN all parts that will get thread lock. I don’t mean wipe them off, I mean nitro cleaner, or soak them in denatured alcohol. Once that’s done, wipe any remaining residue off, and make sure its all dry. 2nd step. Without getting grease on the threads, apply a small amount of black grease (ae brand) to the pivot points of the CVD. Not a lot! Just enough to reduce friction, and stress. 3rd step. Assemble the CVD, and apply a GENEROUS portion of RED ( yes I said RED) thread lock to the grub screw. I also apply Loctite to the threads inside the coupling. VERY IMPORTANT: Before you put that grub screw in, make sure you have the flat spot on that pin right where you need it. When you tighten this grub screw down, ONLY tighten up to the pin. DO NOT OVER TIGHTEN IT!!! They wi
Related Questions
- How can I calculate the final operating conditions (current, speed, etc.) for a motor+gearhead combination given the torque load at the output shaft of the gearhead?
- What is the operating speed and output torque of the steering servo (part #29126) for the Monster GT at 4.8 and 6 volts?
- What can be done about the slow operating speed of the chainsaw?
