Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

What is the default SNMP timeout used by Software Management? Can I configure it?

April 26, 2017configure Default Management SNMP Software timeout Used

0

Posted

What is the default SNMP timeout used by Software Management? Can I configure it?

3 Answers

0

Posted

A. Software Management makes three attempts to connect to the device using SNMP. The first retry timeout interval of 10 seconds is not configurable. Subsequent retry timeout intervals are configurable and are based on the value in the slow timeout variable. To verify the timeout value, select Admin > Essentials > System Configuration. If the initial attempt to connect to the device fails, Software Management waits three minutes before it attempts to connect again. The three minute wait enables routing protocol or spanning tree convergence to occur, which could have been initiated because another device was rebooted during the software upgrade. The number of retries is not configurable. The underlying Software Management stack also tries three times to connect to the device. All the secondary addresses configured in DNS for the device are tried during each attempt.

0

Posted

A. Software Management makes three attempts to connect to the device using SNMP. The first retry timeout interval of 10 seconds is not configurable. Subsequent retry timeout intervals are configurable and are based on the value in the slow timeout variable. To verify the timeout value, select Resource Manager Essentials > Administration > System Configuration. If the initial attempt to connect to the device fails, Software Management waits three minutes before it attempts to connect again. The three minute wait enables routing protocol or spanning tree convergence to occur, which could have been initiated because another device was rebooted during the software upgrade. The number of retries is not configurable. The underlying Software Management stack also tries three times to connect to the device. All the secondary addresses configured in DNS for the device are tried during each attempt.

0

Posted

Software Management makes three attempts to connect to the device using SNMP. The first retry timeout interval of 10 seconds is not configurable. Subsequent retry timeout intervals are configurable and are based on the value in the slow timeout variable. To verify the timeout value, select Resource Manager Essentials > Administration > System Configuration. If the initial attempt to connect to the device fails, Software Management waits three minutes before it attempts to connect again. The three minute wait enables routing protocol or spanning tree convergence to occur, which could have been initiated because another device was rebooted during the software upgrade. The number of retries is not configurable. The underlying Software Management stack also tries three times to connect to the device. All the secondary addresses configured in DNS for the device are tried during each attempt.