What is involved in a new Navman installation?
o Candle advises: Instructions should come with the unit. First, you must install the flow meter mechanism by cutting the fuel line and inserting the measuring device. Just make sure you give yourself some room to tighten the clamps. Next, you must route the cable from the flow mechanism through your conduit and up under the console. I used a pull string and silicone grease to aid the pull. Cutting the hole into the console is no big deal. Once you decide on a location, place duct tape or painter’s tape over the area and use a sharp hole saw. The tape should prevent chipping of the gelcoat. Now comes the challenge. You must remove the ignition switch and solder a pigtail to the switch terminal. I think it’s the yellow wire. Ask Hobo. Then electrically attach the power cable from the NAVMAN to the pigtail and ground the other side. This way, the NAVMAN comes on when you turn the ignition switch. The challenge is that the ignition switch is very compact and has little space in which to m
