What equipment will the SuperBar tune?
It was designed primarily to align and tune the tablesaw. It will check motor arbor run out, to be sure it is within specification It will check saw flange mount for run out; this could cause saw blade wobble Align the saw blade [or MasterPlate] parallel to the miter slot within thousandths of an inch. Square the saw blade [or MasterPlate] to the tablesaw surface. Center the splitter to the saw blade. Square the miter gauge to the saw blade. Align the scoring blade [ if applicable] parallel to the miter slot and centered to the blade. Align the rip fence parallel to the miter slot. Adjust the fence to any required toe-in, toe-out dimension recommended by your saw manufacturer. Check the rip fence for warpage. Once everything is aligned correctly, install the saw blade and rotate by hand to check it for run out. The dial indicator could also be used to check run out on drill presses, shapers, lathes, routers, band saw wheels etc.
