What commands are available using the Serial interface?
Once the cable is connected properly, the clock will display a sign-on message on the terminal when it powers up. The command ‘X’ is used to get the clock’s attention (interactive mode). A prompt will show: Command(B,C,D,F,G,H,K,L,M,N,P,R,S,T,U,V): B: Toggle Burn-in Prevention C: Toggle Calibration Output D: Set Date F: Set Clock Face Mode G: Toggle GPS NMEA input Parsing H: Show extended Help K: Toggle the Fractional Seconds Display L: Toggle LED Blinking M: Toggle 1PPS Trigger Mode N: Set Numeric Display Mode P: Set Clock Play Mode R: Reset the EEProm Configuration Data S: Show Status info T: Set Time U: Set Automatic Daylight Saving Time Adjustment V: Toggle Verbose Output Execution of any of these commands, or another ‘X’ will end the interactive mode. Prompts will time out after 30 seconds. Note that the commands can be given in either upper or lower case.
Related Questions
- tool to ping a router, the destination IP address is the Ethernet interface rather than the serial interface. What determines the default destination interface for a ping?
- When NETLABAE loads a configuration file, the Ethernet, FastEthernet, or Serial interface commands are rejected?
- What commands are available using the Serial interface?
