What causes the fault “LEAP Disabled”?
A. LEAP is considered enabled only when following conditions are set in the access point (on the Radio Data Encryption (WEP) page): –Network-EAP is selected. –If Open authentication type is selected, then Require EAP must also be selected. –If Shared authentication type is selected, then Require EAP option must also be selected. The LEAP Disabled fault is generated if above criteria is not met. The following are possible scenarios that can produce the Leap Disabled fault: –You selected Open authentication type and Require EAP. This will cause the fault because Network-EAP is not selected. – You selected Network-EAP and Share authentication type. This will cause the fault because Required EAP under Share is not selected. If you only selected Network-EAP, the fault will not be generated.
