What are some troubleshooting tips for FROTH-PAK?
If your spray pattern becomes noticeably different (eg. cone spray changes to stream), this may be caused by dispensing foam with a used nozzle. Always inspect a nozzle prior to dispensing to make sure you have an unused nozzle mounted in the INSTA-FLO gun dispenser. If the foam or spray pattern does not react properly, replacing the nozzle will usually correct the problem. If the problem persists, remove the nozzle and carefully activate the dispenser (without a nozzle attached) into a waste container. Two chemical streams of approximately equal volume should flow. If streams are unequal, a blockage has occurred. Shut off the tank valve on the side that is flowing properly and activate the trigger full force for 15 seconds. Once the blockage is freed, turn off all tank valves. Use a rag to clean any chemical from the face of the INSTA-FLO dispenser and reapply petroleum jelly. Insert an unused nozzle, open all valves and dispense a test shot into a waste container. After curing check
