What are Manual Setpoints and how are they entered?
Manual Setpoints are direct setpoint entries. When a manual setpoint is entered the controller immediately sends the process to the selected setpoint value. There is no time (ramp) associated with manual setpoints. IMPORTANT – When a control channel is selected for Manual Mode the decimal point in the Setpoint Display field for that channel is changed to the letter “m” indicating that the channel is in Manual. A manual mode setpoint overrides programmed setpoints. To run a program and use programmed setpoints the channel “must” be changed from Manual back to Programmer Mode. The control channels can be assigned to the manual mode based on the 620A/600A’s configuration. 620A or 600A: Single Channel – Only CH1 is available and can be selected for Manual Mode operation. Two Channel – Either one or both channels can be selected for Manual Mode operation. 620A Only: FastTRAC – Only CH1 can be selected for Manual Mode. In this configuration CH2 receives its setpoint internally from CH1. To c
