What are line hunt groups?
A line hunt group is a feature that allows you to access an available phone line by dialing 9, or 81 to 88, rather than checking each line one at a time. By default TalkSwitch is configured to hunt group 9 so that it will check each line starting at Line 4, through to Line 1. You have the ability to modify this or any other hunt group. Lines are hunted in the order they are listed in the TalkSwitch configuration software, under the System Information -> Line Hunt Groups -> Set Line Hunt Group section. Both my lines flash simultaneously during incoming calls yet I only have one line. This will occur if phone lines are not wired correctly. We suggest using single-line phone cable (two-wire cable) to connect TalkSwitch to your lines. Connect the single-line phone cord between the unit and the phone jack and see if the problem persists. To check if a cord is single-line or two-line cord, look at a jack on either end of the cord. If there are two gold pins, then it is a single-line cord. If
