What are crop circles and how can I get rid of them?
Crop circles are caused due to the endpoints of an arc entity not matching the beginning of the next entity it is attached to. Below are a few steps that can be used before actual redrawing of the geometry is necessary. 1. First check and make sure that your dialog digits match on the cad side to the decimal digits on the cam side. This can be accomplished by going to File/Environment and clicking the Coordinates tab on the cad side. These digits should be set to match what your machine supports which is typically four. Then open the Cam side by selecting your post processor from Special/NC-CAM menu and select the Setup/Coordinates menu. Make sure the decimal digits match what you had on the Cad side. 2. Go back to File/Environment on the Cad side of the software and click the General Tab. Check your general accuracy settings. The default value for this is 0.00004″. We recommend that you set this to .0001″ 4 decimal places, as well you may also you may want to set the chain gap to the
