What application methods are required to apply Cooling Coil Coating?
Use one of the three following application methods: A. Remove Blower Motor, see applicable service manual i. Clean any debris from the plenum and evaporator surface. ii. Apply AirSept Cooling Coil Coating directly to the evaporator through the blower motor opening. iii. Use the flexible wand to direct product over the entire evaporator and surrounding gasket surfaces. iv. When the application is complete, reinstall the blower motor. B. Remove Blower Resistor/Fin Sensor Access Panel, (fig. 1) or see applicable service manual i. Clean any debris from the plenum and evaporator surface. ii. Apply AirSept Cooling Coil Coating directly to the evaporator through the blower resistor/fin sensor panel opening iii. Use the flexible wand to direct product over the entire evaporator and surrounding gasket surfaces. iv. Reinstall the blower resistor/fin sensor access panel, when the application is complete. C. If neither of the previous two access options are available, drill a hole in the plenum. i
