We have two EasySystem manual powder coating box units and would like to use a tribo gun. Is this possible?
There is an adaptor for the TG-1 tribo gun to enable it to work with the EasyTronic control unit; however, there are a couple of drawbacks.A tribo gun uses rinse air from the control unit to create the tribo charge. With the EasyTronic, there are two settings for rinse air and neither one is really high enough to work properly. The highest setting available on the EasyTronic is the minimum necessary to operate a tribo gun, and there is no way to increase this setting. It would be better to be able to increase the rinse or swirl air to increase the tribo charge. Another problem is that we read the current feedback of the tribo gun to display a charge setting or amount of charge. Because the EasyTronic does not display current or KV, you will have no way to know how much charge the gun is creating. All is not lost – there is a better option available! If you wish to use a tribo gun, you should consider upgrading to an OptiTronic control unit. With the OptiTronic, you can adjust the rinse
