Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

VisualMill gives a “Dongle driver error” when started up. How do I fix this?

April 26, 2017dongle driver error Fix gives STARTED VisualMill

0

Posted

VisualMill gives a “Dongle driver error” when started up. How do I fix this?

1 Answer

0

Posted

This message usually means that the hardware key (dongle) drivers were not properly installed. You can fix this problem by installing the drivers. Please follow these instructions to fix the problem. For Users with USB Dongle (Hardware Key) 1. Close VisualMill/RhinoCAM and remove the USB dongle. 2. Go to http://www.safenet-inc.com/support/tech/sentinel.asp and select Sentinel Super Pro 3. Download and Run the SSD Cleanup v1.1 4. Restart your computer 5. Go to http://www.safenet-inc.com/support/tech/sentinel.asp and select Sentinel Super Pro 6. Download and Run Sentinel Protection Installer v7.3.0 7. Plug the dongle back in and launch VisualMill/RhinoCAM For Users with Parallel Dongle (Hardware Key) 1. Close VisualMill/RhinoCAM. 2. Go to http://www.safenet-inc.com/support/tech/sentinel.asp and select Sentinel Super Pro 3. Download and Run the SSD Cleanup v1.1 4. Restart your computer 5. Go to http://www.safenet-inc.com/support/tech/sentinel.asp and select Sentinel Super Pro 6.