Things to check during troubleshooting of pairing issues would include firewalls between the sites and is the recovery site running VC successfully?
I’m configuring the SRDF SRA and although we replicated storage and it contains VMs I still don’t see “replicated LUNs”. After checking all the configuration settings on the SRA side, SRM side and the SAN we noticed that the SPC-2 bit was not enabled. This setting is mandatory according to the FC San Config Guide(page 57) and solved our issues. “Failed to connect to the management system address when executing the discoverArrays command.” You should not often see this but it can be addressed by making sure the SRA is in fact installed on the recovery side. You may also need to check routing between the sites (in particular to the Recovery side SRA / storage management interface. How do I change the SRM change of power state time out values? The default value is 120 seconds which might not be long enough and could lead to issues when a power off is forced of a VM. You can increase or decrease this value by editing the SRM configuration file (vmware-dr.xml). Look for the following sectio
Related Questions
- The eIRB requires me to enter a non-OHSU site other than the sponsor on the "Non-OHSU Study Activities" form but no non-OHSU sites other than the sponsor are used. What should I do?
- How is Norfolk Navigator different than other site selection sites/services?
- Who has access to the Connect with Math Recovery site?
