The SR 3 LCD screen says Im adjusting one thing, but the Drag Net device adjusts something else, at least momentarily. Why is that?
Typical scenario: Page 1 of the SR adjusts Level 1, Page 2 adjusts Level 2. When you switch from Page 1 to Page 2 there’s a lag, during which the SR is still adjusting Level 1. This is most likely due to an incorrect or excessive setting of one of the timeout parameters within the SR 3. Use SR Configurator to check if the SR 3’s Knob Bump Auto Page mode is enabled, and if so check the Update Timer parameter. Two or three seconds is a good starting point for most applications.
