The most important question: how are we going to make the crucial connection to the distributor from the output of the coil?
Since I am using the stock air box, I do not have much room on the flat even top of my distributor, so I couldn’t do an installation like the one on project Mazda: so I did this: Cut off plastic insulation, and threaded the aluminum stud with a tap and die set. Then soldered a ring terminal on the end of the high voltage coil wire, and bolted it from either side to the stud. then I dremeled off any remaining stud, so that I would have minimum modification to do to the rest of the distributor. I used RTV silicone to completely seal the entire connection that was made inside of the distributor cap.
Related Questions
- If the 3DTV Magician has two output jacks for the control of 2 sets of IT-325 Connection Box, what is the need to have a switch to reverse the left/right eye dominance?
- I noticed a loose/broken wire at the coil termination point in the baseplate (the one where the Red output cable is connected), is this anything to be concerned about?
- The most important question: how are we going to make the crucial connection to the distributor from the output of the coil?
