The Inspection Report skips numbers.What causes this?
The Inspection Report will skip numbers if: – The CAD file pattern didn’t meet FabriVISION’s CAD file requirements. For instance, FabriVISION can’t read the radius of a circle made up of two arcs. Therefore, that radius measurement is omitted. – Comments in the CAD file are assigned a number, but the number doesn’t print on the report.
Related Questions
- If the Lancet case report did not say MMR causes autism, and if his collection of biopsies for research purposes was pre-approved by the Ethical Practices Committee, why is there a case against Dr. Wakefield (and colleagues)?
- WHAT AREAS ARE CONSIDERED TO BE INACCESSIBLE ON THE INSPECTION REPORT?
- The Inspection Report skips numbers.What causes this?
