The bed I purchased has a Puretime digital timer on it already, but we need to connect it to a wall timer. How do I make the two work together?
The Puretime bed timer needs to be set so the 3rd Party Interface (3P) parameter is set to 1. To do this it helps to have someone help you. First, cut off the power to the bed/timer. When you turn the power on, you will see the timer go through a boot up sequence. When the display shows a double dash (–) on the screen, press and hold SET TIME and START/STOP at the same time. When the screen goes blank, release the buttons. This boot up sequence is pretty quick, so it helps if you have someone that can cut the power off and back on for you, so you can watch the screen for the (–) on the display. Once into the Parameters the first display you will see is OP, then a number. When the display shows the number, press START/STOP, to advance to the next parameter. It will show the next parameter and the setting (number). After the number press START/STOP again…Continue doing this until you see the 3P on the display. After the 3P it will display a zero (0). Press SET TIME to change the parm
Related Questions
- The bed I purchased has a Puretime digital timer on it already, but we need to connect it to a wall timer. How do I make the two work together?
- How do I connect a RCA / phone plug to the balanced input of the digital crossover?
- I have one wall(exterior) aerial, can i connect 3 other tvs wire free from that?
