Power indicator blinks red. What does it mean?
——————————————————————————– Smart-Clip Support, Quick Guides Smart-Clip user’s manual Download (83 kb) SmartMoto user’s manual Download (18 kb) Operation instruction Power on the Smart-Clip and E/G indicator will light green. Power on the phone without SIM card and flash card (if present). Connect phone to Smart-Clip and press the “Unlock” button ( red on older clips ). E/G indicator will light green and go off, the phone will switch off (some models will automatically turn on then). E/G will light green on success or red on error Successful unlock resets User Code to 1234, Security Code to 000000 Pinout P2K (standard + forced boot) Sendo snd2xx/snd3xx/snd5xx/snd6xx/snd8xx unlocking procedure Power off the phone Connect clip to the phone using RJ45 cable (pinouts below) Press UNLOCK button Press Power button on the phone within 5 seconds after you press UNLOCK button on a clip. RX/TX leds will blink E/G led will glow green on success
Most likely you are using Smart-Clip battery for power. The red light of power indicator shows low battery charge. Please replace battery and resume your work. Thomas, I have some info for SmartClip and Griffin users. After update SmartClip (use LPT Port), please restart computer. If not, you can not use Griffin (BAD ACTIVATION STATUS on Griffin). After restart PC, Griffin will work normaly. This problem occur on my PC (Mother Board by Asus). Don’t know about others MB. Hope this info can help some users. BR, Adam www.ats-com.
Smart-Clip Support, Quick Guides Smart-Clip user’s manual Download (83 kb) SmartMoto user’s manual Download (18 kb) Operation instruction 1. Power on the Smart-Clip and E/G indicator will light green. 2. Power on the phone without SIM card and flash card (if present). 3. Connect phone to Smart-Clip and press the “Unlock” button ( red on older clips ). 4. E/G indicator will light green and go off, the phone will switch off (some models will automatically turn on then). 5. E/G will light green on success or red on error 6. Successful unlock resets User Code to 1234, Security Code to 000000 * Pinout P2K (standard + forced boot) Sendo snd2xx/snd3xx/snd5xx/snd6xx/snd8xx unlocking procedure 1. Power off the phone 2. Connect clip to the phone using RJ45 cable (pinouts below) 3. Press UNLOCK button 4. Press Power button on the phone within 5 seconds after you press UNLOCK button on a clip. RX/TX leds will blink 5. E/G led will glow green on success. When you unlock Sendo phone use either fully
